Skip to content

Hadron Dynamic Overdrive

Based On
Lovepedal® Eternity
Effect Type
Build Difficulty
Project Summary
An early entry in the minimalist Tube Screamer category, this was one of the circuits that kicked off the hand-built boutique pedal industry.
Hadron Dynamic Overdrive printed circuit board

Printed Circuit Board

What's included?
PCB only. Build instructions and parts list can be viewed or downloaded from this page.


In stock

Complete Kit

Not yet available.
Kits are developed based on interest, so if you’d like to see one for this project, let us know.
Request Kit
40 people are interested.

Project overview

The Hadron Dynamic Overdrive is a recreation of the Lovepedal Eternity, first released in 2005. There have been several versions of the Eternity throughout the years, with names like Burst, Fuse, Kanji, D-Mod, and Roadhouse. However, they all have the same basic circuit. The provided parts list is based on the original Eternity, but you should be able to build almost any version if you know what changes to make. The differences are typically only in the component values used and the number of clipping diodes.

Like the Zendrive, the Eternity can be seen as a stripped-down Tube Screamer, based on the original 1997 Son of Screamer circuit by Jack Orman. It’s essentially a Tube Screamer without input & output buffers. This makes it interact better with a guitar’s volume & tone knobs, but on the flip side it also interacts with the pedals that come before & after.

Alongside the Azimuth, the Hadron has among the lowest parts count of any Aion FX project and is a very good starting point for new builders.